Is this your problem? Do you have questions like these? Question 1>>> Sealing and film feed occur at the same time. So, for high-speed operation, the sealing time is too short and sealing faults occur... Question 2>>> From adjustment to full operation can take up to 30 minutes. And each seal has to be checked for strength. This takes skill so it can't be done by just anyone... If only we could be sure that the adjustment would continue through to full operation... Question 3>>> Printing pitch matching is OK, but if the bag widths are not the same their quality as merchandise drops off badly... Question 4>>> Handling mark sensors is plenty of trouble, difficult too! If you don't adjust it, or adjust it badly, you finish up using lots of the film roll... It's really probrem! Question 5>>> Is the same sealing pressure OK for wide seals and narrow seals? Is that what causes unsightly sealed surfaces? I'm also worried about the strength of the bag... Question 6>>> I wonder if seals vary in strength because of temperature irregularities in the heat-sealers? Question 7>>> What's this about being careful with cooling water? Question 8>>> There's a limit to remembering the data for proper adjustment, written notes are a nuisance, subject to error and inconvenient. Just seeing a data print-out would be convenient and easily kept but it would be good if the machine could remember and it didn't have to be entered. Question 9>>> The film roll powder brake has to be adjusted several times while the machine is working. Can't something be done about that? Question 10>>> Whenever there's a joint in the film there's a major film loss. Losses like that are no joke. Question 11>>> What are you doing about safety? I don't like a machine that can hurt me, no matter how good it is! Question 12>>> What is the warranty period for components? Corporate Profile | Product Information | Totani News | Exhibition | World Wide Locations | Contact Us

5-81 Nakakuze-cho, Kuze, Minami-ku, Kyoto 601-8213 Japan TEL.(075)933-7610 FAX.(075)933-7602